ASME - S and U STAMP
Authorized Manufacturer
Fabrication Capabilities
Plant Process manufactures vessels, heat exchangers, piping systems and structures under various applicable codes. All unfired vessels are constructed with ASME certification for unfired pressure vessels, Section VIII, Division I and are tested and stamped on nameplates accordingly. In addition, metallic repairs, alterations and all vessels carry national board certification and registration. Plant Process welders are qualified under ASME Section IX and piping systems are constructed under ANSI B31.1, B31.3, B31.5 and B31.8 or where necessary to any other standard required by the Client’s project specification. Our in-house testing procedures and welding qualifications assure that our welders are qualified under these procedures for permit vessels and pipe construction with carbon steel, stainless steels, aluminum, monel, inconel and other alloys.
Pressure Vessels
American Society of Mechanical Engineers
Section VIII - Division 1
Piping
American Society of Mechanical Engineers -
ASME B3.1.1 / 31.3/ 31.8
Welding Qualifications
ASME Section IX
AWS D1.1
Welding Technologies
FCAW
GTAW
GMAW
SAW
Our in-house testing procedures and welding qualifications assure that our welders are qualified under these procedures for permit vessels and pipe construction with carbon steel, stainless steels, aluminum, monel, inconel and other alloys.
Heat Treatment
High Pressure Stress Relief
The West building has a 560’ offset which houses the new heat treat furnace with interior measurements of 8’ x 10’ x 25’.
The furnace has a weight capacity of approximately 40,000 lbs. and all the necessary controls and instrumentation to stress relieve our manufactured vessels. The maximum temperature on furnace is 1300 degrees. The West building is equipped with two 20 ton cranes.
The addition of a new 9’ x 9’ SAW welder complements our existing 12’ x 12’ SAW unit.